MCE Touch AEP Series - Automatic Washing Cycle; Cup Heating Device (Optional)

•
8
.
Automatic washing cycle
This coffee machine is suited with an automatic washing cycle. To complete this function, proceed as follows:
Replace the normal filter of the filter-holder with a blind one;
Pour a teaspoon of a suitable detergent powder on the blind filter;
Attach the filter-holder to the brewing group;
Hold down the doses and (the midle ones) until the automatic washing cycle starts: the relevant touch pad’s
green led will blink;
While the automatic washing cycle is enabled, the green leds are on and the red ones blink;
After finishing the cycle, replace the blind filter with the normal one and repeat the washing cycle one more time by pressing
the doses and , so as to remove any residual detergent;
Make the washing cycle for the other groups, just as described herewith.
The automatic washing cycle can take effect contemporary at more groups.
i
Group solenoid valve
Cycle start
Pump
Cycle end
5” 5” 5” 5”
5” 5” 5”
5” 5” 5” 5”
5” 5” 5”
•
•
•
•
•
•
•
The number of cycles for automatic washing is set to 4. The cycles are performed as shown in the bellow diagram:
Cup heating device (optional)
The cup heating device has the functionality of pre-heatting the cups just before usage:
Place the cups on the cup heater surface
(1) of the coffee machine;
Put the cup-heater switch
(2) on position ON.
9.
AEP version
For safety reasons, it is advisable not to place on the cup heater device anything but cups, so not to obstruct
the air flow.
i
•
•
1
2
13
AEP - SAE
english