McHale 991B Round Bale Wrapper
43
8.1.10 Total Reset
If for some reason the date in the instrument is corrupted or the display shows “PrOg”
then the instrument must be totally reset.
Switch power off
Press and hold all 3 control switches
Switch power on
Release all switches
All instrument settings should be returned to the factory-set values. If the display shows
“PrOg” again, the instrument may be faulty and must be returned to the manufacturer
for inspection and repair.
The third digit flashes
Hold to cycle to the desired digit, then release, otherwise
press once...
The fourth digit flashes
Hold to cycle to the required digit.
Release all
To Next Page
Loading...
