What to do if the cut & hold is not closing on my McHale Stretch Wrapping Systems?
If the cut and hold mechanism on your McHale Stretch Wrapping Systems is not closing, the pressure on the accumulator might be too high. Release pressure from the accumulator.
What to do if the cut & hold is not opening on my McHale 991BC Stretch Wrapping Systems?
If the cut and hold mechanism on your McHale Stretch Wrapping Systems is not opening, the pressure on the accumulator might be low. Prime the accumulator to resolve this issue.
Why is the control box not counting on my McHale 991BC?
If the control box on your McHale Stretch Wrapping Systems isn't counting, the sensor might be damaged, or the magnet broken. Locate and replace them. Adjust the sensor approximately 10-15 mm from the magnet. If these steps do not solve the issue, the control box may be faulty and require replacement.
Why is the table stopping in the wrong position on my electronic McHale Stretch Wrapping Systems?
If the table on your electronic McHale Stretch Wrapping Systems is stopping in the wrong position, reset the magnets. Ensure you start with the cut & hold at the rear of the machine. Adjust the slow down setting in the control box. Check the electrical connections for the slow speed valve. Clean the dirt in slow speed cartridge. Ensure that you set table rotation to 10 rpm.
Why is the plastic not stretching on my McHale Stretch Wrapping Systems?
If the plastic isn't stretching on your McHale Stretch Wrapping Systems, it could be due to a buildup of tack/glue on the dispenser rollers. Clean them off with kerosene. Alternatively, the torsion spring on the dispenser might be weak, in which case you should replace it.
General| Brand | McHale |
|---|---|
| Model | 991BC |
| Category | Stretch Wrapping Systems |
| Language | English |
To Next Page
