What to do if the cut & hold is not closing on my McHale 991BE?
If the cut and hold mechanism on your McHale Stretch Wrapping Systems is not closing, the pressure on the accumulator might be too high. Release pressure from the accumulator.
What to do if the cut & hold is not opening on my McHale 991BE Stretch Wrapping Systems?
If the cut and hold mechanism on your McHale Stretch Wrapping Systems is not opening, the pressure on the accumulator might be low. Prime the accumulator to resolve this issue.
Why is the control box not counting on my McHale 991BE Stretch Wrapping Systems?
If the control box on your McHale Stretch Wrapping Systems isn't counting, the sensor might be damaged, or the magnet broken. Locate and replace them. Adjust the sensor approximately 10-15 mm from the magnet. If these steps do not solve the issue, the control box may be faulty and require replacement.
Why is the table stopping in the wrong position on my electronic McHale 991BE?
If the table on your electronic McHale Stretch Wrapping Systems is stopping in the wrong position, reset the magnets. Ensure you start with the cut & hold at the rear of the machine. Adjust the slow down setting in the control box. Check the electrical connections for the slow speed valve. Clean the dirt in slow speed cartridge. Ensure that you set table rotation to 10 rpm.
Why is the plastic not stretching on my McHale 991BE Stretch Wrapping Systems?
If the plastic isn't stretching on your McHale Stretch Wrapping Systems, it could be due to a buildup of tack/glue on the dispenser rollers. Clean them off with kerosene. Alternatively, the torsion spring on the dispenser might be weak, in which case you should replace it.
Defines the 'Danger Zone' and outlines safety for repair and reassembly.
Details safety measures during operation and before travelling on public roads.
Provides specific safety warnings related to electronic and hydraulic systems.
Explains the meaning of safety decals and provides their part numbers.
Details how to set up the hydraulic spool valve based on tractor system type.
Details joystick operation for the 991 BJS model and table locking procedures.
Introduces the Bale Wrap Computer and available programs for control.
Guides on selecting programs and explains the functions of different data channels.
Describes the electronic control box interface and models it applies to.
Lists and explains the functions of each button on the control box.
Explains how to navigate the setup menu and adjust settings.
Describes working display screens and bale counter functions.
Guides on setting target wraps and navigating operator setup.
Explains continuous cycle and auto load setup procedures.
Covers the steps to prepare the wrapper for the wrapping process.
Details loading plastic film and adjusting the side tip bale damper.
Describes the recommended method for wrapping behind the tractor.
Covers wrapping procedures for 991BJS and remote stack wrapping.
Details mandatory checks before travelling on public roads.
Explains how to adjust drawbar and dispenser heights.
Outlines maintenance intervals and daily checks for the machine.
Covers procedures for end-of-season storage and start-of-season preparation.
Troubleshoots common issues with the lift arm and table.
Addresses problems related to plastic film and bale damper operation.
Troubleshoots issues with control boxes and hydraulic systems.
General| Brand | McHale |
|---|---|
| Model | 991BE |
| Category | Stretch Wrapping Systems |
| Language | English |
To Next Page
