Need help?Do you have a question about the McIntosh C 504 and is the answer not in the manual?
Describes the phono amplifier's integrated circuit, low noise design, RIAA compensation, and input specifications.
Explains the active circuitry for the high level/loudness amplifier, including feedback loops.
Details the equalizer amplifier's construction and its three series tuned circuits for frequency control.
Describes the push-pull Class AB amplifier driving main outputs and headphone jack, including turn-on delay.
Explains the electronic FET analog switches used for low-level, noise-critical input selection.
Describes the phono amplifier's integrated circuit, low noise design, RIAA compensation, and input specifications.
Explains the active circuitry for the high level/loudness amplifier, including feedback loops.
Details the equalizer amplifier's construction and its three series tuned circuits for frequency control.
Describes the push-pull Class AB amplifier driving main outputs and headphone jack, including turn-on delay.
Explains the electronic FET analog switches used for low-level, noise-critical input selection.
General| Type | Preamplifier |
|---|---|
| Number of Channels | 2 |
| Total Harmonic Distortion | 0.005% |
| Frequency Response | 20Hz to 20kHz |
| Output Impedance | 100 ohms |
| Outputs | Tape 1, Tape 2 |
To Next Page
