McIntosh C49 User Manual

31
Packing Instructions
Packing Instructions
In the event it is necessary to repack the equipment for
shipment, the equipment must be packed exactly as
shown below. It is very important that the four plas-
tic feet are attached to the bottom of the equipment.
This will ensure the proper equipment location on the
bottom pad. Failure to do this will result in shipping
damage.
Use the original shipping carton and interior parts
only if they are all in good serviceable condition. If
a shipping carton or any of the interior part(s) are
needed, please call or write Customer Service Depart-
ment of McIntosh Laboratory. Refer to page 3. Please
see the Part List for the correct part numbers.
Quantity Part Number Description
1 033838 Shipping carton only
4 033837 End cap
1 033836 Inside carton only
1 033725 Inner carton top pad
1 034576 Bottom pad
2 034446 Foam plug
4 017937 Plastic foot
4 400159 #10-32 x 3/4” screw
4 404080 #10 Flat washer
FOAM PLUG
UNIT WITH
(4) FEET ON
---- ~
BOTTOM COVER
BOTTOM
PAD
INSIDE ~
CARTON
END CAPS
INSIDE
CARTON
SHIPPING
CARTON

McIntosh C49 Specifications

General

Type	Solid State Preamplifier
Total Harmonic Distortion	0.005%
Phono Input Impedance	47k ohms
Headphone Output	Yes
S/N Ratio	100dB
Frequency Response	20Hz to 20kHz +0, -0.5dB
Digital Inputs	2 Coax, 2 Optical, 1 USB, 1 MCT
DAC Type	8-channel, 32-bit/192kHz PCM/DSD
Dimensions	17.5 inches (44.45cm) wide, 6 inches (15.24cm) tall (including feet), 18 inches (45.72cm) deep (including front panel and cables)
Inputs	2 Balanced
Outputs	2 balanced, 2 unbalanced
Signal to Noise Ratio	100dB
Gain	15dB
High Level Input Impedance	20K ohms, Balanced or Unbalanced