27
automatic brief audition of each of the presets stored in the
tuner memory. Press +10 a second time to stop on a station
preset and exit the Review process.
Volume
Press the UpS or DownT VOLUME Push-button to raise
or lower the listening volume level.
Note: The Record Signals present at CDR and SRVR
OUTPUTS are not affected by volume changes.
Amplifier Selection
Press the 2nd push-button followed by the OUTPUT 1 or 2
push-buttons to control the rear panel OUTPUTS 1, 2
which can feed signals to a power amplifier or other acces-
sory component.
Acc On
Press ACC ON to turn the power ON to a McIntosh Disc
Player.
Acc Off
Press ACC OFF to turn the power OFF to a McIntosh Disc
Player.
Pause
Press Pushbutton to perform various functions on a vari-
ety of McIntosh Components. It will also pause the playing
of a disc or tape player. The Push-button will also allow
for quick exiting from the active menu when in the setup
mode. The Push-button is also used as an Enter Push-but-
ton with some McIntosh components.
How to Operate the Remote Control
How to Operate by Remote Control
The supplied Remote Control is capable of directly control-
ling the functions of contemporary McIntosh Source Com-
ponents connected to the C500.
Mute
Press the MUTE Push-button to mute audio. The Record
Signals present at the CDR and SRVR OUTPUTS are not
affected by the MUTE function. The C500 Front Panel Al-
phanumeric Display will indicate the word MUTE. Press
MUTE a second time to unmute audio.
Mono
Press the MODE Push-button to switch Mono Mode On or
Off for the selected Listen Signal.
Trim
Press the TRIM Push-button, followed by the LEVEL UpS
or DownT Push-button to select various sound adjustments
and functions.
Note: Refer to “How to Operate the C500” starting on page
28 for additional information.
Input Source Selection
Press one of the appropriate Source Push-buttons or the In-
put W or X Push-buttons to select the desired program
source.
Note: When directly selecting sources with Title names
ending with a “2” or “3”, the appropriate Numbered
Push-button needs to be pressed after the push-button
with the Titled Name is pressed; e.g. for Input DVD2,
press the DVD Push-button followed by the “2” Push-
button.
Disc, Server and Tape Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Tape Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre-
sets, tracks on discs or selections on a Music Server.
Disc and Track
Use the DISC and TRACK Push-buttons when a Disc
Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel UpS or
DownTPush-button to move from station to station. Press
and hold a Channel UpS or DownT Push-button to move
continuously from station to station. Press +10 to start the
To Next Page
Loading...
Need help?
General
