11
How to use the Remote Control
How to use the Remote Control
The supplied HRO70 Remote Control is capable of
directly controlling the functions of contemporary
McIntosh Source Components connected to the
MA6600 via the Data Ports.
Note: If at any time the MA6600 seems unresponsive to
HRO70 Remote Control Commands press the
Push-button first.
Input Source Selection
Press the appropriate Source Push-button to select the
desired program source.
Mute
Press the MUTE Push-button to mute the audio in all
outputs except the REC OUTPUT. The word MUTE
will appear on the Front Panel Information Display.
To un-mute the audio, press the MUTE Push-button
again. The mute push-button is also used to activate
the special Headphone Mute Mode, refer to page 20
for additional information.
Mono
Press the MONO Push-button to switch from Stereo to
Mono for Monophonic listening.
Disc, Server and Tape Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner sta-
tion presets, tracks on discs or selections on a Music
Server.
Disc and Track
Use the AM(disc)and FM(track)Push-buttons when a
Disc Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel Upp or
Downq Push-button to seek the next available station.
Press and hold a Channel Upp or Downq Push-but-
ton to seek continuously from station to station.
Volume
Press the Upp or Downq VOLUME Push-button to
raise or lower the listening volume level.
Note: The Record Signals present at REC OUTPUTS are
not affected by volume changes.
Pause
Press the Pause Pushbutton to perform various func-
tions on a variety of McIntosh Components. It will
also pause the playing of a disc or tape player.
Trim
Press the TRIM Push-button until the desire Trim
function (Bass, Balance, Trim Level, Treble, etc.)
appears on the Front Panel Information display, then
press the LEVEL Upp or Downq Push-button to
adjust the Trim setting.
Press and release the LEVEL Upp or Downq
Push-button to recall the last Trim Function Selected
and its current setting, additional pressing of the push-
buttons will allow adjustment of the Trim Setting.
Note: For additional information on the Trim Functions
refer to pages 18, 19 and 20.
Acc On/Off
Press ACC ON to turn the power ON or ACC OFF
switches AC Power OFF to McIntosh Components
when connected to the ACC Power Control Jack. Refer
to the SETUP Accessory Power Control on page 15
for additional information.
Amplifier Selection
Press the BLUE (Setup) Push-button followed by the
AM (Output 1) or FM (Output 2) Push-buttons, to con-
trol the rear panel OUTPUTS 1, 2 (ON or OFF). These
OUTPUTS provide signals to a Power Amplifier or
other accessory component.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
