Need help?Do you have a question about the McIntosh MCC404 and is the answer not in the manual?
General| Number of Channels | 4 |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Total Harmonic Distortion | 0.005% |
| S/N Ratio | 105dB |
| Power Output (4 ohms) | 400 Watts |
| Damping Factor | >100 |
| Output Impedance | 4 ohms |
Illustrates connections for four speakers, audio sources, and power.
Details connecting the amplifier's turn-on signal and DC power with fuse.
Illustrates connections for tweeter, mid-range, and bridged woofer with crossover.
Instructions for connecting an external crossover for speaker signal distribution.
Illustrates connections for two bridged amplifiers driving full-range speakers.
Illustrates connections for upper-range speakers and a bridged subwoofer.
Details input connections and filter settings for subwoofer operation.
Details setting input source, sensitivity, and output mode for independent 100W channels.
Guides on setting input source, sensitivity, and output mode for tri-amp configuration.
Specifies high and low pass filter settings for these operating modes.
Explains setting input source, sensitivity, and output mode for bridged 400W channels.
Step-by-step guide for safely replacing fuses, including precautions and knob removal.
To Next Page
