18
McIntosh DVD Player
How to Connect Video Components
How to Connect Video Components
There are three types of Video Signals that can be con-
nected to and selected by the MX135; Composite, S-Video
and Component. The built-in Digital Video Processing Cir-
cuitry can Up-Convert the desired Composite Input to S-
Video; it will also Up-Convert the desired Composite or S-
Video Inputs to Component Video. Connect all of the avail-
able Source Component Video Outputs (Component, S-
Video and Composite), using the appropriate Video Cables
to the MX135. This will assure that video is available to
the Zone B and VCR Outputs. Refer to Input Setup Menu
on page 34 for additional information.
1. Connect video cables from the MX135 DVD VIDEO
INPUTS to the McIntosh Video Outputs of the McIn-
tosh DVD Player.
IN
OUT
VCR
To AC
Outlet
2. Connect video cables from the MX135 DVD COMPO-
NENT INPUT 5 to the McIntosh Component Video
Outputs of the McIntosh DVD Player.
3. Connect video cables from the MX135 SAT VIDEO
INPUTS to the Video Outputs of a Satellite Receiver.
4. Connect video cables from the MX135 SAT COMPO-
NENT INPUT 1 to the McIntosh Component Video
Outputs of a Satellite Receiver.
5. Connect video cables from the MX135 VCR1 INPUTS
to the VCR Video Outputs.
6. Connect video cables from the MX135 VCR1 OUT-
PUTS to the VCR Video Inputs.
7. Connect video cables from the MX135 MON A COM-
PONENT OUTPUTS to the Monitor/TV Component
Video Inputs.
Note: If the Monitor/TV does not have Component Video
Inputs, then connect the MX135 MON A S-Video or
Composite Output(s) instead.
Monitor/TV
Note: If the MX135 A/V System
Control Center has the
TM1 AM/FM Tuner
Module installed, proceed
to page 54 for How to
Connect Antennas
Information.
Satellite Receiver
To Next Page
Loading...
