38
Figure 27
MENU: DIGITAL SETTINGS
ÆRC INPUT TOGGLE: ON
ADVANCED MENU
1. Press and hold the Front Panel SETUP Push-button ap-
proximately three seconds to enter the Setup Mode.
The word SETUP will appear on the MX135 Front
Panel Display and the MAIN SYSTEM SETUP Menu
will appear on the Monitor/TV screen. Refer to figure
6 on page 23.
2. Using the Up or Down directional push-buttons on
the Remote Control, select ADVANCED on the On-
Screen Menu, followed by the SELECT/OK Push-but-
ton. Refer to figure 26.
RC Input Toggle
The MX135 incorporates Automatic Digital/Analog Audio
Input Switching. When a source with an assigned digital
input is selected, the MX135 will automatically search first
for a Digital Audio Signal; if no Digital Signal is sensed, it
switches to the Analog Signal. This RC Input Toggle fea-
ture can be manually overridden at any time by simply re-
selecting that same source by pressing the appropriate Re-
mote Control Push-button. To activate the RC Input Toggle
perform the following steps:
3. Using the Up or Down directional push-buttons,
select DIGITAL SETTINGS from the On-Screen
Menu, followed by the SELECT/OK Push-button.
4. Use the Left or Right directional push-buttons to
Select ON. Refer to figure 27.
5. Using the Up or Down directional push-buttons,
select ADVANCED MENU from the On-Screen Menu,
followed by pressing the SELECT/OK Push-button.
6. Continue to the INPUT SELECT POWER ON Setting.
If you do not wish to perform INPUT SELECT
POWER ON Setting at this time, select the MAIN
MENU. The MAIN SYSTEM SETUP Menu will reap-
pear on the Monitor/TV screen and proceed to the next
step.
7. Select EXIT from the MAIN SYSTEM SETUP Menu.
If you are satisfied with the changes that you may have
made, select YES to save those changes or NO not to
save them. The MX135 will then return to normal op-
eration. Refer to figure 7 on page 24.
Input Select Power On
The MX135 has a feature called Input Select Power On
that allows for easier operation. When an Input Source
Push-button on the Remote Control or Keypad is pressed,
the MX135 will automatically switch-on without first hav-
ing to press the STANDBY/ON Push-button. This feature
may be de-activated by performing the following. Refer to
figure 28.
8. Using the Up or Down directional push-buttons,
How to change the Advanced Settings
select INPUT SELECT POWER ON from the On-
Screen Menu, followed by pressing the Left or
Right directional push-buttons to select OFF.
9. Using the Up or Down directional push-buttons,
select the MAIN MENU. The MAIN SYSTEM
SETUP Menu will reappear on the Monitor/TV screen
and proceed to the next step.
10. Select EXIT from the MAIN SYSTEM SETUP Menu.
If you are satisfied with the changes that you may have
made, select YES to save those changes or NO not to
save them. The MX135 will then return to normal op-
eration. Refer to figure 7 on page 24.
Figure 26
MENU: ADVANCED
ÆDIGITAL SETTINGS
INPUT SELECT POWER ON: ON
VERSION CHECK
RESTORE DEFAULTS
MAIN MENU
To Next Page
Loading...
