31
The MX135 has twelve Analog Audio Inputs numbered 0
through 11, six Digital Audio Inputs lettered A through F
and five Component Video Inputs numbered 1 through 5.
These inputs already have assigned titles and associations
that will allow for immediate hookup, operation and enjoy-
ment.
If these starting assignments and associations do not match
up with components in your system, they may be reas-
signed from the default settings. The following example
will illustrate how to rename the TAPE2 Input to DVD2
and assign it the LV Digital Input. When the Zone A or B
Input Selector is rotated to select what was originally the
TAPE2 Input, DVD2 will now appear on the Front Panel
Alphanumeric Display. The Surround Mode, Video Power
Control, Video Converter Input and Component Video can
also be set for each Input.
Notes: 1. The very first time the INPUT SETUP is accessed, the
default settings will be indicated.
2. Unused Inputs may be switched Off so that they will
not appear when rotating through the input source
choices using the Zone A or Zone B Input Selector and
also will not be available when using the Remote
Control or Keypad.
3. If the MX135 is connected to either a CR16 or CR12
Multizone Controller, refer to Important Information
note number 7 on page 5.
1. Press and hold the Front Panel SETUP Push-button ap-
proximately three seconds to enter the Setup Mode.
The word SETUP will appear on the MX135 Front
Panel Display and the MAIN SYSTEM SETUP Menu
will appear on the Monitor/TV screen. Refer to figure
6 on page 23.
2. Using the Up or Down directional push-buttons on
the Remote Control, select INPUT SETUP on the On-
Screen Menu, followed by the SELECT/OK Push-but-
ton. Refer to figure 6 on page 23.
3. Using the Up or Down directional push-buttons,
select SOURCE INPUT from the On-Screen Menu,
followed by pressing the Left or Right directional
push-buttons to select Input Number 5 - IR-TP2. Refer
to figure 15.
Note: The information displayed after the Source Input
Number indicates which IR Remote Control
Command selects the input.
Analog Audio/Video Input Title
4. Using the Up or Down directional push-buttons,
select TITLE, followed by pressing the SELECT/OK
Push-button. The On-Screen Menu Title can now be
changed from the default name. Refer to figure 16.
How to Change the Input Setup
5. Using the Up or Down directional push-buttons,
select “D” as the first character of the new title.
Note: The TITLE may be up to 4 characters in length
including (0 thru 9) and (A thru Z).
6. Press the Right directional push-button to select the
second character position of the title.
7. Using the Up or Down directional push-buttons to
select “V” the second character of the title.
8. Select the two remaining characters “D” and “2” of the
title by using the directional push-buttons.
9. Press the SELECT/OK Push-button once and then
press the Down directional push-button.
SETUP, con’t
MENU: INPUT SETUP
ÆSOURCE INPUT 5 - IR-TP2
TITLE TAPE2
DIGITAL INPUT NONE
ZONE A ANALOG INPUT RCA
SURR MODE LAST
VIDEO POWER ON
COMPONENT VIDEO NONE
VIDEO CONV INPUT OFF
MAIN MENU
Figure 15
Figure 16
MENU: INPUT SETUP
SOURCE INPUT 5 - IR-TP2
ÆTITLE A
DIGITAL INPUT NONE
ZONE A ANALOG INPUT RCA
SURR MODE LAST
VIDEO POWER ON
COMPONENT VIDEO NONE
VIDEO CONV INPUT OFF
MAIN MENU
To Next Page
Loading...
