McQuay RoofPak RAH 047C - Control Locations

McQuay IM 487-4 7
Introduction
Control Locations
All controls are optional. If controls are ordered, Figure shows
the locations of the various control components mounted
throughout the units. See “Control Panel” on page 8 for the
locations of control components mounted in control panels.
Additional information is included in Table 2 on page 15 and
the wiring diagram legend, which is included in “Wiring
Diagrams” on page 57. Figure shows the blow-through heat
and the blow-through coil sections.
Figure 7. Control locations cftc f C CX F
Economizer
Filter
DX
Heat
section
Supply fan
discharge
plenum
section
C19, 20
RAT
LT11 (optional)
S11, REC11
SD2
RAE
ACT3
PC5
OAE
VM1
LT10 (optional)
DAT
OAT
SV1, 2
(optional)
section
section
return air
(optional)
(optional)
(optional)
(optional)
C9
FS1
(optional)
SV5, 6 (optional)
S10, REC10 (optional)
SD1 (optional)
ACT6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com