Need help?Do you have a question about the MDS GP4 and is the answer not in the manual?
Fuse power wire within 12" of battery for car protection.
Protects speakers from DC voltage by shutting down the amplifier.
Shuts down amplifier if speakers or wiring short to ground.
Shuts down amplifier if it overheats and resumes when cooled.
Use appropriate gauge wire, connect to +12V terminal, and use an inline fuse.
Use a short, thick ground wire connected to a clean chassis point.
Connect to radio's remote output or power antenna wire for turn-on.
Connect one speaker to bridged terminals for mono output.
Check fuses, RCA cables, power, ground, and fader settings.
Re-adjust levels, check RCA cables, and ensure proper level matching.
Check grounds, RCA cables, and vehicle charging system for noise sources.
Check for speaker shorts, ground issues, or low impedance.
Fuse power wire within 12" of battery for car protection.
Protects speakers from DC voltage by shutting down the amplifier.
Shuts down amplifier if speakers or wiring short to ground.
Shuts down amplifier if it overheats and resumes when cooled.
Use appropriate gauge wire, connect to +12V terminal, and use an inline fuse.
Use a short, thick ground wire connected to a clean chassis point.
Connect to radio's remote output or power antenna wire for turn-on.
Connect one speaker to bridged terminals for mono output.
Check fuses, RCA cables, power, ground, and fader settings.
Re-adjust levels, check RCA cables, and ensure proper level matching.
Check grounds, RCA cables, and vehicle charging system for noise sources.
Check for speaker shorts, ground issues, or low impedance.
To Next Page
General