Need help?Do you have a question about the MDS GP800 and is the answer not in the manual?
Disconnect the car's battery before making any connections to avoid electrical system damage.
Fuse the power wire within 12" of the battery to protect the car's battery from short circuits.
Make ground wires as short as possible and ground all components at the same point to reduce resistance and ground loops.
Use 4-8 gauge wire for +12V connection to the battery, with an in-line fuse within 12" of the battery.
Use 4-8 gauge wire to connect the GND terminal to the car's chassis, ensuring a clean, short connection.
Check for blown fuses, bad RCA cables, power/remote connections, and fader settings.
Ensure clean grounds, proper grounding points, and use shielded RCA cables to reject noise.
Check speaker connections for shorts, impedance, and ensure adequate airflow for overheating.
Disconnect the car's battery before making any connections to avoid electrical system damage.
Fuse the power wire within 12" of the battery to protect the car's battery from short circuits.
Make ground wires as short as possible and ground all components at the same point to reduce resistance and ground loops.
Use 4-8 gauge wire for +12V connection to the battery, with an in-line fuse within 12" of the battery.
Use 4-8 gauge wire to connect the GND terminal to the car's chassis, ensuring a clean, short connection.
Check for blown fuses, bad RCA cables, power/remote connections, and fader settings.
Ensure clean grounds, proper grounding points, and use shielded RCA cables to reject noise.
Check speaker connections for shorts, impedance, and ensure adequate airflow for overheating.
General| Channels | 2 |
|---|---|
| Signal to Noise Ratio | >100dB |
| THD | <0.05% |
| Power output | 800W @ 4 ohms |
| Impedance | 4 ohms |
| Frequency Response | 20Hz - 20kHz |
| Input Impedance | 20kΩ |
To Next Page
