Page 2-2
July 2005 2047ES / 2647ES / 3247ES Operator’s Manual
UNLOADING PROCEDURES
♦ Inspect the outside of the machine for damage. Inspect all hoses, beam assemblies
(armset), and cables for chafing or road damage. Confirm that all wheel lug nuts are
tight (refer to the “Machine Specifications”).
♦ Unlock and open side compartments. Inspect all electrical and hydraulic connections
for damage and security.
♦ Turn battery switch to ON position. Check electrolyte level.
♦ Check engine oil level and add as required per engine manufacturer’s recommenda-
tions.
♦ Check that fluid level is to the fill mark on the hydraulic tank and add fluid as re-
quired (see “Lubrication Chart”).
♦ Close side compartments.
ALWAYS ATTACH THE MACHINE TO A WINCH WHEN
LOADING OR UNLOADING FROM A TRUCK OR TRAILER IF
DRIVEN OFF. WE DO NOT RECOMMEND UNASSISTED
LOADING OR UNLOADING OF ANY SCISSOR LIFT.
READ AND UNDERSTAND ALL SAFETY, CONTROL, AND
OPERATING INFORMATION FOUND ON MACHINE AND IN THIS
MANUAL BEFORE OPERATING THE MACHINE.
♦ Attach the machine to a winch for the unloading.
♦ Perform Machine Start-up procedures in this section. Refer to Operator Controls
Descriptions, as necessary.
♦ Remove all machine tie downs. Remove wheel chocks, if used. Turn the Base/
Platform selector switch to the “PLATFORM” position.
♦ Enter the platform, activate emergency stop switch (rotate clockwise and release).
Test all platform functions.
♦ Carefully drive the machine off the truck or trailer with the winch still attached.
NOTE: The brakes are automatically released for driving and will automatically
apply when the machine stops.
♦ Before placing the machine into service, all operators must read and under-
stand the contents of this Operator’s Manual.
Courtesy of Crane.Market
To Next Page
Loading...
