9
www. mechmaxx.com
ASSEMBLY
ASSEMBLY
Loosen the nut on the front side of the back frame just
enough so the top link bracket can be rotated 180° for
the next assembly step.
Orient the top link bracket so that it is rotated 180° from
how it was shipped in the previous step.The hitch pin
must be on top. Secure it to the back frame using four (4)
M12 X 40 mm hexbolts, M12 flat washers,and Spring
washer 12.
TOP LINK BRACKET
Using the hardware listed below, assemble the deflector
to the flywheel housing as shown.
DEFLECTOR
Using the hardware listed below, assemble the chainsaw
holder to the flywheel housing as shown.
CHAINSAW HOLDER
Hex lock nut M12
Hex bolt M12 X 40mm
Flat washer 12
Spring washer 12
4X
4X
4X
Hex lock nut M83X
Hex bolt M8 X 30mm
Flat washer 8
3X
6X
To Next Page
Loading...