mectron Silverlight - Page 9

9
silverlight - manual of use and maintenance
Description of signaling for the recharging unit:
(Table 1):
Green Power
LED
Battery LED
Green Red
Position of
Silverlight in the
recharging unit
Function
ON OFF OFF Not in place Recharging unit powered
ON ON OFF In place Battery being recharged
ON OFF OFF In place
Recharging completed.
Battery charged.
ON OFF ON In place Battery failed.
ON OFF ON Not in place
Electric contacts of the
recharging unit short-
circuited.
�
WARNING: Do not tamper with the recharging unit electrical contacts.
The recharging unit recognizes the battery state. If after some exposure cycles the battery is not at
enough when the handpiece is placed on the recharging unit, the green battery LED does not switch on.
This is normal.
Description of the acoustic signals of the handpiece:
(Table 2)
Function Push-button control Acoustic signal
FAST polymerisation
Brief pressure of push
button
1 beep on starting exposure
1 beep on completing exposure (10
seconds)
SLOW RISE polymerisation
Pressure of push button
for at least 2 seconds
1 beep when starting and 1 beep after 2
seconds
1 beep after 10 seconds of exposure
1 beep on completing exposure (20
seconds)
Interruption of exposure
cycle
Pressure of push button
during exposure
1 beep
Battery low signal. The
residual charge is sufcient
for 6 cycles.
2 beeps on completing the exposure
cycle
Battery dead signal
Pressure of push button
for FAST or SLOW RISE
polymerisation
2 beeps - No light emission
Thermal protection signal 3 beeps during the exposure cycle