How to fix mectron Medical Equipment that won't turn on?
If your mectron Medical Equipment isn't turning on, there are a few things to check: * Ensure the power cable is firmly connected to the socket on the rear of the device. * If the cable is properly connected, the power cable may be faulty and need to be replaced. * Also, the fuses might be unserviceable and need replacement.
What to do if no liquid comes out of the insert during mectron Medical Equipment operation?
If no liquid is coming out of the insert during operation of your mectron Medical Equipment, consider the following: * Ensure you are using an insert designed for liquid through-flow. * Check that the PUMP function is not set to zero. If it is, press the + key on the front panel. * Verify the liquid bag is full. * Make sure the drip system's air intake is open. * Confirm the tubes of the drip system and pump are correctly installed. * Check if the insert is clogged and, if so, clear the blockage.
What to do if mectron Medical Equipment shows ERR on display and does not work?
If your mectron Medical Equipment is on but not working and displays 'ERR', try these steps: * Ensure the insert is correctly fitted into the handpiece by unscrewing it and screwing it back in. * If the insert is worn, broken, or deformed, replace it. * Check the connector of the cord and dry the connectors if they are wet.
Why is my mectron Medical Equipment losing power?
If you are experiencing insufficient power with your mectron Medical Equipment, consider these potential causes: * The insert may not be correctly fitted to the handpiece. Unscrew the insert and screw it back into place correctly. * The insert might be worn, broken, or deformed and may need replacing. * The insert may require maintenance.
What to do if mectron Medical Equipment is on but not working with no errors?
If your mectron Medical Equipment is switched on but not working, and no errors are displayed, verify that the footswitch connector is properly plugged into the socket.
How to stop whistling sound from mectron Medical Equipment handpiece?
If you hear a faint whistle from the Piezosurgery handpiece of your mectron Medical Equipment during operation, the insert may not be correctly tightened. Unscrew the insert and then screw it back into place correctly.
Why is the pump being forced on my mectron Medical Equipment?
If the pump is being forced on your mectron Medical Equipment, it may be due to too much pressure by the impeller on the tube in the peristaltic pump. Check that the tube in the peristaltic pump has been correctly inserted.
Why does liquid come out of the mectron Medical Equipment handpiece after the pump stops?
If liquid comes out of the handpiece of your mectron Medical Equipment after the pump stops, ensure that the door of the peristaltic pump is properly closed.
Essential safety precautions that must be followed during the installation phase.
Step-by-step instructions for connecting all the necessary accessories to the Piezosurgery unit.
Detailed explanation of the front panel controls and their specific functions.
Detailed steps for executing the CLEAN function to flush the hydraulic circuit.
Step-by-step guide for the steam autoclave sterilization of the device's inserts.
Procedures for cleaning and autoclaving the torque wrench used for inserts.
General| Brand | mectron |
|---|---|
| Model | Piezosurgery II |
| Category | Dental equipment |
| Language | English |
To Next Page
