MEDCAPTAIN SYS-6010 - Page 20

16
Red light flashing
High level alarm
b. The main testing points: none
c. Number and definition of the socket
No.
Socket
PIN
No.
Description
Explanation
1
J1
24
Socket to connect SYS02
board
Connect J1 in the SYS02 board
2.4.10 The pressure& speed detection board
a. The circuit introduction
Main functions are as follows:
(1)Process the pressure sensor signals: amplify and filter signals from the pressure
sensor, output to the power board.
(2)Collect and transfer signals: the peristaltic pump tablets signal, the stepper motor
speed signal, the pump door-open signal, the pump door-off signal and the hall switch
signal are all collected to the pressure& speed detection board through two cables to the
power board.
(3)Switch the driving signal: switch the driving signals from the door-open motor and
infusion motor through controlling the relay.
Note: the pressure sensor and the infusion pump pressure& speed detection board should
be adjusted and tested together, therefore, they need to be replaced one to one
correspondence, or there be a new debugging.
b. The main testing points: none
c. Number and definition of the sockets
No.
Socket
PIN
No.
Description
Explanation
1
J1
7
Socket to connect the
power board
Connect J4 in the power board
2
J2
8
Socket to connect the
power board
Connect J3 in the power board
3
J3
4
Socket to connect the
pressure sensor
Connect the pressure sensor
4
J4
4
Socket to connect the
stepper motor speed
board
Connect the stepper motor
speed board
5
J5
3
Socket to connect the
pump tablets testing board
Connect the pump tablets testing
board
6
J6
6
Socket to connect the hall
switch board
Connect the hall switch board
7
J7
4
Socket to connect the
power board
Connect J7 in the power board
8
J8
4
Socket to connect the
Connect the open motor