Connections
Connecting an Audio Equipment
When using an amplifier, connect the Output L/MONO and R
jacks on the rear panel to the input of the amplifier.
Note:
For mono playback, use the L/MONO jack.
For stereo playback, connect both L/MONO and R jacks.
The line output volume is controlled by the VOLUME knob.
Connecting a set of Headphones
An optional set of stereo headphones can be connected to the
PHONES jack located on the side of the drum module.
The headphones output volume is controlled VOLUME knob,
too.
Connecting an MP3/CD Player
Connect the audio output of an MP3/CD player or other audio
source to the stereo AUX IN jack on the rear panel.
The input signal is mixed with the drum signal, allowing you to
play along.
Connecting a Computer
Via the USB Connector
This receives and transmits MIDI messages.
Via the MIDI Connectors
MIDI IN Connector
This receives MIDI messages transmitted from an external
MIDI device or a computer.
MIDI OUT Connector
Pad performance data is transmitted from this connector to
connected computer or MIDI device.
Connecting a Midi Keyboard
If you’re using an external MIDI keyboard or pads to control the
digital drum, make connections as shown. Here, it is used as a
sound module.
Power Supply & Switch
Make sure the power is switched OFF. Connect the power
adaptor to the DC IN jack on the side panel. After confirming
that all connections have been completed, rotate the volume
knob to the left (minimum volume level) before switching the
power on. Set the power switch to the “ON” position. The KIT
indicator on LCD will light up and the display will show kit
number 01.
Note:
Make sure the power is switched OFF when connecting the
drum module with external devices.
7
To Next Page
Loading...
Need help?
General
