Plug an audio cord into the PHONE jack.
Then plug the other end of the cord into
LINE IN or AUX IN of the amplifier.
Check to make sure that the keyboard
" ".
Plug a microphone into the MIC IN jack.
's
power switch is set to off
Note:
Use only the monaural microphone for
this function (microphone not included).
Playing the Keyboard
1.
To turn on the keyboard, set [power]
to ON. The display lights.
Note:
For reminding you in power saving, the
keyboard automatically sounds a voice
"Ding Dong" about every 2 minutes to
alert you to switch off the unit when
not in use.
Adjust the volume to your desired
level. Repeatedly press [master
volume] up or [master volume]
down to increase or decrease the
volume. The keyboard's volume
ranges from 0 (no sound) to 9
(Maximum) and the current volume
level appears on the display.
2.
6
From 0 to 9
Connecting an Amplifier
Connecting a Microphone
Playing the Songs
You can listen to any of the 100 songs
listed at the right panel. Each song plays
the preset tone of the melody.
1.
2.
2
Press [song]. The display indicates
"SONG" and the code of the current
song.
Choose a song from the SONGS list
and enter its two-digit number on the
keypad.
You can press [-] or [+] to move up or
down to the next song.
Press [start/stop] to start playing the
song.
3.
3
6
From 00 to 99
5
To Next Page
Loading...
Need help?
General
