MEDENUS R 100 - Tools; Brace and Bit with 4-Jaw Chuck29; SSV Tightening Tool

29
© 05.2022
13 Tools
13.1 Brace and bit with 4-jaw chuck
The 3.5 - 16 mm brace and bit with 4-jaw chuck and the accessories available for it
are used for precise adjustment of the setpoint spring in your MEDENUS gas pressure
regulator.
For further information for use and on the spring data of the setpoint springs, please
refer to pages 12 - 13 "Initial commissioning / Recommissioning" and pages 14 - 15
"Diaphragm assembly setpoint spring table".
13.1.1 Accessories for brace and bit with 4-jaw chuck
Gedorescrewdriverbit1/2“slotted18x2.5mm
• HexagonsquaredrivetoDIN3120-C12.5,ISO1174,withballgroove
• Hand-operated,withslip-proofcrossknurling
• Chrome-plated
• With pressed-in pin made of GEDORE vanadium special steel, manganese-
phosphatized
• CuttingbladetoDINISO2380-1formB
Gedoreextension1/2“76mm
• ModeltoDIN3123,ISO3316
• Forhand-operatedsocketwrenchinsertswithsquaredrivetoDIN3120,ISO1174,
with ball detent
• GEDOREvanadiumsteel31CrV3,chrome-plated
Gedoreextension1/2“76mm
• ModeltoDIN3123,ISO3316
• Forhand-operatedsocketwrenchinsertswithsquaredrivetoDIN3120,ISO1174,
with ball detent
• GEDOREvanadiumsteel31CrV3,chrome-plated
13.2 SSV Tightening Tool
The tightening tool made of stainless steel is used for
replacing the SSV diaphragm in your MEDENUS safety
shut-off valve.
Old design
• Width across flats 22
• Stainless steel 42CrMo4
New design
• Width across flats 32
• EN AW-2007 or similar
Old design
New design