FOREWORD
The ltration unit is designed for dry particles only and must never be used for extracting
liquids.
When not in use or during maintenance always isolate the equipment from the electrical
supply by removing the mains plug from the socket.
PREPARATION FOR USE
Unpack and check equipment against the delivery note.
Check the details on the equipment rating label conform to your electrical supply.
For assembly instructions please refer to page 3.
IMPORTANT. THIS EQUIPMENT MUST BE EARTHED.
The wires in the mains lead of this equipment are coloured in accordance with the following
code:
GREEN AND YELLOW EARTH
BLUE NEUTRAL
BROWN LIVE
In the event of the wire colours in the mains lead not corresponding with the terminal
markings of your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the terminal marked
with either the letter E, or coloured green and yellow, or the earth symbol.
The wire which is coloured blue must be connected to the terminal marked with the letter
N, or coloured black.
The wire which is coloured brown must be connected to the terminal marked with the let-
ter L, or coloured red.
If a 240V model is to be tted with a plug of the 13 amp. fused type to BS1363 then a 13
amp. fuse must be tted.
If a 110V model is to be tted with a 110V plug to BS4343 the supply must be provided with
a 16 amp. protective device.
Environmental conditions for transport and storage.
To Next Page
Loading...