CUTTING HINTS
The Medezine 5000 oscillating saw has been designed and constructed to provide
eortless and highly ecient cutting in its appropriate areas of usage. We suggest a trial
cutting period applying the least pressure possible to the workpiece until fully accustomed
with the eciency. Excessive pressure is not required as this will reduce the speed of cut.
If you experience diculty then consult the Troubleshooting Causes and Solutions on pages
10 and 11.
Suitable safety protection must be worn at all times during cutting.
DISINFECTION AND STERILIZATION
The saw unit only is capable of withstanding temperatures between - 20 degrees C to
+70 degrees C. This must be born in mind when considering a disinfection or sterilization
method.
Autoclaving of this equipment is not recommended.
Only use cleaning agents that are safe for use on metals. We do not recommend the use of
Hydrochloride or corrosive cleaners as possible corrosion could result.
We advise gentle scrubbing with a soft non metallic brush, rinsing with clean water and
drying where necessary. Do not direct high pressure water jets at any part of the equipment,
this could invalidate the warranty.
All cleaning agents should be mixed, stored and applied according to the manufacturers
instructions.
Note. Normal safety precautions should be observed when mixing or applying any
cleaning agents, such as the wearing of suitable eye protection, protective clothing
and gloves. Always refer to the manufacturer’s recommendations.
12
To Next Page
Loading...