13
EN
5.7
Memory– cancellation of all measurements
Before you delete all readings stored in the memory, make sure you
will not need refer to the readings at a later date. Keeping a written
record is prudent and may provide additional information for your
doctor’s visit. In order to delete all stored readings, depress the
MEMORY button for at least 5 seconds, the display will show the
symbol “CL” and then release the button. To permanently clear the
memory, press the MEMORY button while “CL” is ashing. To indicate deletion of
stored readings.
6. Appearance of the Pulse Arrhythmia
Indicator for Early Detection
This symbol “ ” indicates that certain pulse irregularities were detected during
the measurement.
In this case, the result may deviate from your normal blood pressure – repeat the
measurement. In most cases, this is no cause for concern. However, if the sym-
bol appears on a regular basis (e.g. several times a week with measurements
taken daily) we advise you to tell your doctor.
Please show your doctor the following explanation:
Information for the doctor on frequent appearance of the Arrhythmia indicator
This instrument is an oscillometric blood pressure monitor that also analyses
pulse frequency during measurement. The instrument is clinically tested. The
arrhythmia symbol is displayed after the measurement, if pulse irregularities
occur during measurement. If the symbol appears more frequently (e.g. several
times per week on measurements performed daily) we recommend the patient to
seek medical advice.
The instrument does not replace a cardiac examination, but serves to detect
pulse irregularities at an early stage.
To Next Page
Loading...