14
EN
7. Error Messages / Malfunctions
If an error occurs during a measurement, the measurement is discontinued and a
corresponding error code is displayed.
Error No. Possible cause(s)
ERR 1 No pulse has been detected.
ERR 2 Unnatural pressure impulses inuence the measurement result. Reason:
The arm was moved during the Measurement (Artefact).
ERR 3 The ination of the cu takes too long. The cu is not correctly seated.
ERR 5 The measured readings indicated an unacceptable dierence between
systolic and diastolic pressures. Take other reading following directions
carefully. Contact you doctor if you continue to get unusual readings.
ERR 8 The pressure in the cu is too high (over 290 mmHg).
Further Information - The level of blood-pressure is subject to uctuations even
with healthy people. Important thereby is, that comparable measurements always
require the same conditions (Quiet conditions)! If, in spite of observing all these
factors, the uctuations are larger than 15 mmHg, and / or you hear irregular
pulse tones on several occasions, please consult your doctor. For licensing, the
device has been subjected to strict clinical tests, by which the computer program
used to measure the blood-pressure values was tested by experienced specialist
doctors in Germany. The same computer program is used in every individual
device, and has thus also been clinically tested. The manufacture of the devices
takes place according to the terms of the European standard for blood-pressure
measuring devices (see technical data) you must consult your specialist dealer
or chemist if there are technical problems with the blood-pressure instrument.
Never attempt to repair the instrument yourself! Any unauthorized opening of the
instrument invalidates all warrantee claims!
To Next Page
Loading...