Mediblink M520 - Page 20

20
EN
Note1: At 80 MHz and 800 MHz, the higher frequency range applies.
Note2: These guidelines may not apply in all situations. Electromagnetic propagation is a󰀨ected by absorption and reection from structures, objects,
and people.
a
Field strengths from xed transmitters, such as base stations for radio (cellular / cordless) telephones and land mobile radios, amateur radio,
AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due
to xed RF transmitters, an electromagnetic site survey should be considered. If the measuredeld strength in the location in which the M520
with MDI is used exceeds the applicable RF compliance level above, M520 with MDI should be observed to verify normal operation. Ifabnormal
performance is observed, additional measures may be necessary, such as reorienting or relocating M520 with MDI.
b
Over the frequency range 150 kHz to 80MHz, eld strengths should be less than 3 V / m.
Recommended Separation Distances:
Recommended separation distance between portable and mobile RF communications equipment and M520 with MDI.
M520 with MDI is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or
the user of M520 with MDI can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile
RF communications equipment (transmitters) and M520 with MDI as recommended below, according to the maximum output power of the
communications equipment.
Rated maximum output
power of transmitter (W)
Separation distance according to frequency of transmitter m
150 kHz to 80 MHz
d = 1.2×p
1 / 2
80 to 800 MHz
d = 1.2×p
1 / 2
800 MHz to 2.5 GHz
d = 2.3×p
1 / 2
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.2 1.2 2.3
10 3.8 3.8 7.3
100 12 12 23
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be determined
using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer.
Note1: At 80MHz and 800MHz, the separation distance for the higher frequency range applies
Note2: These guidelines may not apply in all situations. Electromagnetic propagation is a󰀨ected by absorption and reection from structures,
objects and people.
Manufacturer Information:
Shenzhen Combei Technology Co, Ltd.
11-5B, No.105, Huanguan South Road,
Dahe Community Guanlan, Longhua District,
ShenZhen, Guangdong, China
MedNet EC-REP GmbH
Borkstrasse 10
48163 Münster
Germany
Manufactured for
(Importer for EU & Distributor):
Mediblink d.o.o.
Gubčeva cesta 19
8210 Trebnje
Slovenia
info@mediblink.com
www.mediblink.com
Instructions for use, version No:
M520-2019-V01
Issue date:
17.12.2019
Date of last change:
13.07.2022