24
Suspending the device on a wall
You can also suspend the device on a wall without an addi-
tional picture frame. Two lugs are attached on the back of the
device for this.
Suspend the device by the lugs, on a nail with sufficient
load-bearing capacity for the required position.
Connecting the device to the elec-
tric network
CAUTION!
Damage to the device is possible in the case of
the use of a different power pack!
Use the power pack supplied exclusively.
Attach the connection cable to the DC IN 5V connection
socket on the base of the device.
Plug the power pack into a well accessible mains socket
with 230 V ~ 50 Hz mains voltage.
To Next Page
Loading...