35
Fixing the display characteristics
You can adjust the following display characteristics to your
requirements:
Brightness
Contrast
Colour
Select the “Display” sub-menu.
Press the OK button.
The sub-menu will be opened.
Setting the image brightness
Select the ‘Brightness’ menu point.
Press the OK button.
The current setting will be displayed as a bar below on the
screen. This bar will be sub-divided into 15 stages.
The stage set will be displayed at the right of the bar. The
higher the stage set, the brighter the screen will be.
Press the RIGHT navigation button until the required value
is displayed, to increase the brightness.
Press the LEFT navigation button until the required value is
displayed, to reduce the brightness.
Press the OK BUTTON to take over the set value.
Press the ESC navigation button to leave the menu point.
To Next Page
Loading...