25
Switching the device on and off
Push the mains switch on the base of the device to the ON
position, to switch the device on.
You will see a start screen for a short time after switching the
device on. A slide show will be started afterwards.
The storage location for the photos in this slide show will be
selected automatically as follows:
The photos on that storage medium will be displayed, if
you have connected a storage medium in the card slot.
The photos from the USB storage medium will be dis-
played, if you have connected a USB storage medium to the
device and no storage medium has been inserted in the
card slot.
The photos from the internal memory will be displayed, if
you have not connected a storage medium either at the
card slot or at the USB connection.
The selection menu for the data source will be displayed, if
no image data is stored in the device (see Page 43).
You will be able to adjust the settings for the slide show as you
require, as described from Page 39.
Push the mains switch on the base of the device to the OFF
position, to switch the device off.
Detach the power pack from the socket, to separate the
device from the electricity network completely.
To Next Page
Loading...