The Remote Control
62
Operation
The TV card fits into the Express Card slot of your notebook.
Note
The TV tuner card only fits into an Express Card/54 slot. Do not put
the card into any similar slots. That could lead to damage to the
notebook or the card.
Inserting the TV card
Note
Remove the dummy card from the Express Card/54 Slot before
installation. Replace the card to protect contacts against dirt if the
Slot is not used.
1. After starting Windows
®
, slide the card carefully into the proper slot as far as
it goes. The card then rebounds by a few millimetres and locks into place.
Two short signals, confirming successful installation, will sound if the card
has been pushed in completely.
2. Start the application for TV reception, in order to set up the TV card. A set-up
assistant will guide you through the program.
Removing the TV card
Remove the TV card in the following manner:
1. Disconnect all cables.
2. Press on the card slightly in the direction of the slot and then let go of it. The
card sticks out from the slot and can be removed. Store it in a safe place.
Note
If the card remains in the device and is not in use, move the on/off-
switch to the left (the LED goes out). If you want to use the card
again, move the switch to the right. The LED lights up.
To Next Page
Loading...
