Slit Lamp Microscope USER MANUAL
3 / 29
General Requirements for Safety
Dear customers, please read the instruction manual carefully before using our products to avoid
accidental mechanical hazards and improper use of the user, resulting in unclear images and
diagnostic errors. In particular, carefully read the following safety precautions to prevent the product
is damaged, personal injury, and other hazards and accidents that may occur.
1 The product can only be used by qualified medical staff.
2 Do not disassemble or attempt to perform operations that are not described in this
instruction manual. If the operation is not performed properly, excessive force may
cause damage to the machine or personal injury. If the instrument fails, please read the
troubleshooting guide carefully; follow the troubleshooting methods and steps to
troubleshoot the problem; if the problems remain unsolved, please contact our
Manufacturer and Service Department, and our company will arrange professional
maintenance personnel to help you troubleshoot.
3 Do not store and use in a flammable, explosive, high temperature, high humidity and
dusty environment; use it in a clean room, keeping the product clean and dry.
4 Other medical instruments and equipment that installed at the same site must comply
with the same electromagnetic compatibility principles. Equipment that cannot
comply with or is known to have poor electromagnetic compatibility must be installed
at least 3 meters away from the equipment and must be powered by a different power
cord.
5 Please pay attention to the rating of all electrical connection ports.
6 Before using the instrument, please check all the wires are correctly connected; if the
wires are inappropriately connected it may cause the instrument to be short-circuited,
which may cause the product is damaged and personal injury.
7 Users should pay attention when using the instrument, and be careful when moving
the parts to avoid damage due to the moving of the base and tilting of the projection
tube
8 When replacing fuses and other electrical components, turn off the main power
switch. Replace the fuse that meets the specifications specified in this manual.
9 If there is an need to replace power cord, please use the power cord specified in this
manual. 。
10 Don’t touch the surface of the lens and prism with hand or hard objects.
11 When the device is not operating, the power should be turned off, and cover the
device with dust cover.
12 To prevent the instrument from falling down to floor, it should be placed on the floor
where the inclination angle is less than 10°.
13 Please deal with the waste disposal produced by the machine following relevant laws
and regulations.
To Next Page
Loading...
