13
n Launch Device
Click Launch Device or double click the NetAgent listed in the table to launch it.
Enter the Account (Login Name) and Password (Login Password) set earlier to
login. If you did not configure one, then just click Apply to login.
o Configure
Choose the Netagent UPS from the right of the screen, then click “Configure”,
would shows the following setting page.
IP Address:Set IP address for Netagent UPS
When use at the first time, please set IP address; subnet mask; and gateway.
After setting, enter IP address from Telnet or Browser to connect to Netagent’s
website.
When using DHCP or BOOTTP to set up IP address, IP address, Subnet Mask
and Gateway would receive directly by the system.
Fig.11 Netility : Set IP address for NetAgent UPS
Advanced:Advanced Netagent UPS Setting
In order to ensure the secure management of UPS, Netility provides two
protecting function:
Netility Password
After password setting here, there is no way to give any command to Netagent
by Netility software without user’s password. (NB. If lose this password,
Netagent UPS will never be able to complete any upgrade process.)
Management Protocol
Netagent UPS provides HTTP(WEB) and Telnet to reference any related
parameter setting for the manager. Concerning with security, the manager
could build use openly or any advance port setting upon the above two
methods. Followings are the description:
1. At advanced setting, two functions were set as activated by using port
number 80 and 23.
2. Untick means not using the function.
To Next Page
Loading...
Need help?
General
