Megger KMK 8 - Page 8

1-2
In TDR mode KMK 8 can be used, to locate…
• Open ends
• Shorted conductors
• Water damage
• Screen faults (interruption)
• Loose connectors
• Crimp faults
• Simple or double split
• Branches
• Capacitance networks
• Unwanted loading coils
• Change of cable type
In active bridge mode KMK 8 provides:
DC fault location methods like:
• Murray,
• 3 Point
• Küpfmüller
• Repeated Küpfmüller
AC fault location methods like:
• Line break
• Repeated Küpfmüller
The measurement of parameters like:
• Loop resistance
• Resistance difference
• Insulation resistance
• Cable capacity
• Capacitive unbalance
• AC, DC voltage
In passive bridge mode KMK 8 provides:
DC fault location methods like:
• Murray,
• Küpfmüller
• 3 Point
AC fault location methods like:
• Küpfmüller
• Capacitive unbalance