The instrument circuit contains static sensitive devices, and
care must be taken in handling the printed circuit board. If the
protection of an instrument has been impaired it should not
be used, and be sent for repair by suitably trained and
qualified personnel. The protection is likely to be impaired if,
for example, the instrument shows visible damage, fails to
perform the intended measurements, has been subjected to
prolonged storage under unfavourable conditions, or has
been exposed to severe transport stresses.
New Instruments are Guaranteed for 1 Year from the
Date of Purchase by the User.
Note: Any unauthorized prior repair or adjustment will
automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for MEGGER® Instruments
contact:
AVO INTERNATIONAL or AVO INTERNATIONAL
Archcliffe Road Valley Forge Corporate Centre
Dover 2621 Van Buren Avenue
Kent, CT17 9EN. Norristown, PA 19403
England. U.S.A.
Tel: +44 (0) 1304 502243 Tel: +1 (610) 676-8579
Fax: +44 (0) 1304 207342 Fax: +1 (610) 676-8625
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair companies have
been approved for repair work on most MEGGER®
instruments, using genuine MEGGER® spare parts. Consult
the Appointed Distributor / Agent regarding spare parts,
repair facilities and advice on the best course of action to
take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it
should be sent freight pre -paid to the appropriate address. A
copy of the Invoice and of the packing note should be sent
simultaneously by airmail to expedite clearance through
Customs. A repair estimate showing freight return and other
charges will be submitted to the sender, if required, before
work on the instrument commences.
Repair and Warranty
15
To Next Page
Loading...
