Repair and Warranty
23
The Test set circuit contains static sensitive devices, and care must be taken in handling the printed circuit
board. If the protection of a product has been impaired it should not be used, and be sent for repair by
suitably trained and qualified personnel. The protection is likely to be impaired if, for
example, the product shows visible damage, fails to perform the intended measurements, has been
subjected to prolonged storage under unfavourable conditions, or has been exposed to severe
transport stresses.
New Products are Guaranteed for 1 Year from the Date of Purchase by the User.
Note:
Any unauthorized prior repair or adjustment will automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements contact:–
Megger Limited or Megger
Archcliffe Road Valley Forge Corporate Center
Dover 2621 Van Buren Avenue
Kent, CT17 9EN Norristown, PA 194
England U.S.A.
Tel: +44 (0) 1304 502243 Tel: +1 (610) 676-8579
Fax: +44 (0) 1304 207342 Fax: +1 (610) 676-8625
or an approved repair company.
Approved Repair Companies
A number of independent companies have been approved for repair work on most Megger products,
using genuine Megger spare parts. Consult the Appointed Distributor / Agent regarding spare parts, repair
facilities and advice on the best course of action to take.
Returning a Test Set for Repair
If returning a test set to the manufacturer for repair, it should be sent freight pre-paid to the
appropriate address. A copy of the Invoice and of the packing note should be sent simultaneously by
airmail to expedite clearance through Customs. A repair estimate showing freight return and other charges
will be submitted to the sender, if required, before work on the instrument commences.
To Next Page
Loading...
