Why does the auxiliary DC voltage source malfunction in Megger Programma Sverker 750 Test Equipment?
The thermal cut-out (thermal relay) may have tripped because of an overload. Wait. This cut-out is reset automatically after a certain amount of time has elapsed.
Why is the phase-angle not 0° on Megger Programma Sverker 750?
You have connected a Sverker adjusted for 230 V / 50 Hz to 230 V / 60 Hz.
What does a flashing value mean on Megger Programma Sverker 750?
The value shown is less than 1% of the range being used.
What does 'BAD START CONDITION' mean on Megger Programma Sverker 750?
Select another start condition.
What does 'BAD STOP CONDITION' mean on Megger Test Equipment?
Select another stop condition.
General| Frequency Range | 15 - 500 Hz |
|---|---|
| Communication Interface | USB, Ethernet |
| Power Supply | 100-240 V AC, 50/60 Hz |
| Voltage Output Range | 0-300 V AC/DC |
| Current Output Range | 0 to 30 A |
| Phase Configuration | Single-phase |
| Accuracy | 0.1% of setting |
| Display | LCD |
To Next Page