SLM770A Module Hardware Design Manual
MeiG Smart Technology Co., Ltd 77/77
RF warning for Mobile device:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01 guidance, the
following conditions must be strictly followed when using this certified module:
KDB 996369 D03 OEM Manual v01r01 rule sections:
2.2 List of applicable FCC rules
This module has been tested for compliance to FCC Part 15 22 24 27
2.3 Summarize the specific operational use conditions
The module is tested for standalone mobile RF exposure use condition. Any other usage conditions such as
co-location with other transmitter(s) or being used in a portable condition will need a separate reassessment
through a class II permissive change application or new certification.
2.4 Limited module procedures
Not application
2.5 Trace antenna designs
Not application
2.6 RF exposure considerations
This equipment complies with FCC mobile radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your
body. If the module is installed in a portable host, a separate SAR evaluation is required to confirm compliance
with relevant FCC portable RF exposure rules.
2.7 Antennas
The following antennas have been certified for use with this module; antennas of the same type with equal or
lower gain may also be used with this module. The antenna must be installed such that 20 cm can be maintained
between the antenna and users.
To Next Page