2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID: 2APJ4-SLM770A”.
The grantee's FCC ID can be used only when all FCC compliance requirements are met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or simultaneous
transmission with other transmitter(s) or portable use will require a separate class II permissive change
re-evaluation or new certification. 2.10 Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does not cover the FCC Part 15 Subpart B
(unintentional radiator) rule requirement applicable to the final host. The final host will still need to be reassessed
for compliance to this portion of rule requirements if applicable.
As long as all conditions above are met, further transmitter test will not be required. However, the OEM integrator
is still responsible for testing their end-product for any additional compliance requirements required with this
module installed. IMPORTANT NOTE:
In the event that these conditions cannot be met (for example certain laptop configurations or co-location with
another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be used on
the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate FCC authorization. Manual Information to the End User:
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove
this RF module in the user’s manual of the end product which integrates this module. The end user manual shall
include all required regulatory information/warning as show in this manual
OEM/Host manufacturer responsibilities
OEM/Host manufacturers are ultimately responsible for the compliance of the Host and Module. The final product
must be reassessed against all the essential requirements of the FCC rule such as FCC Part 15 Subpart B before it
can be placed on the US market. This includes reassessing the transmitter module for compliance with the Radio
and EMF essential requirements of the FCC rules. This module must not be incorporated into any other device or
system without retesting for compliance as multi-radio and combined equipment.
To Previous Page