W e reserv e the right to change execut ion and constructi on!
MEIKO Maschinenbau GmbH & Co. KG, Englerstr. 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
Contents
Page
1 Introduction and general information 4
1.1 Storage 5
1.2 Name and address of manufacturer 5
1.3 Authorization for service technicians of our service partners 5
1.4 Description of the machine 5
2 Explanation of the safety symbols used 6
3 Use of the appliance for the purpose intended 6
4 CE-Declaration of Conformity 7
5 General safety information 8
5.1 Operator's duty of care 8
5.2 Basic safety measures 9
6 Delivery, shipping, installation and assembly 11
6.1 Delivery 11
6.2 Transport, installation and assembly 11
6.3 Operating conditions 12
6.4 Requirements for the electrical connection 12
6.5 Requirements for the fresh water connection 13
6.6 Requirements for the waste water connection 14
6.7 Emergency-off 14
6.8 Chemicals for the operation of the appliance 14
6.9 Instructions for the disposal of the packaging material 14
7 Settings for initial commissioning by the service engineer 15
7.1 Commissioning 15
8 Washing with dish-washer 15
8.1 Operating panel 15
8.2 Preparation for washing and rinsing 16
8.3 Automatic dosing 17
8.4 Operation during washing and rinsing cycle 17
9 Shutting down the dishwasher 18
10 Care and maintenance 18
10.1 Care, general 18
10.2 Refilling of detergent 18
10.3 Refilling with rinse aid 19
10.4 Cleaning 19
10.5 Care of stainless steel surfaces 19
10.6 De-scaling 20
11 Machine with built-in water softening device Aktiv Clean (Only for DV 80.2 / DV
120.2 / DV 125.2) 20
11.1 General 20
11.2 Adjustment of water hardness 20
11.3 Capacity of the built-in water softening device between two regenerations depends20
11.4 Regeneration 21
11.5 Error messages 21
12 Basic information on the appliance 21
12.1 General description of the washing machine 22
12.2 Noise level 23
12.3 Data reg. the electrical and hydraulic equipment 23
12.4 Dimensions, technical data, installation instructions 24
13 Non-ionizing radiation 24
14 Tips for self-help in the case of faults 24
15 Staff training 25
To Next Page
