Operating instructions FV 40.2 / FV 40.2 G / FV 60.2
Datei:1_FV40_60-2_9546822_Betriebsanleitung_EN_2004-03.doc Update: 2008-03-10 S. „FV 40 G“ 9544094
2/42
We reserve the right to change execution and construction!
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1174
Contents
Page
1 Introduction and general information 3
1.1 Storage 4
1.2 Name and address of manufacturer 4
1.3 Description of the type of equipment 4
2 Explanation of the safety symbols used 5
3 Use of the appliance for the purpose intended 5
4 General safety information 6
4.1 Operator's duty of care 6
4.2 Basic safety measures 7
5 Delivery, shipping, installation and assembly 8
5.1 Delivery 8
5.2 Transport, installation and assembly 9
5.3 Operating conditions 9
5.4 Requirements for the electrical connection 10
5.5 Requirements for the fresh water connection 11
5.6 Requirements for the waste water connection 11
5.7 Emergency-off 11
5.8 Chemicals for the operation of the appliance 12
5.9 Instructions for the disposal of the packaging material 12
6 Settings for initial commissioning by the service engineer 12
6.1 Commissioning 12
7 Washing with dish-washer 13
7.1
Operating panel 13
7.2 Preparation for washing and rinsing 14
7.3 Automatic dosing 14
7.4 Operation during washing and rinsing cycle 14
8 Shutting down the dishwasher 15
9 Care and maintenance 15
9.1 Care, general 15
9.2 Refilling of detergent 16
9.3 Refilling of rinse aid 16
9.4 Cleaning 16
9.5 Maintenance of stainless steel surfaces 17
9.6 De-scaling 17
10 Machine with built-in water softening device AktivClean 17
10.1 General 17
10.2 Adjustment of water hardness 17
10.3 Capacity of the built-in water softening device between two regenerations depends. 18
10.4 Regeneration 18
10.5 Error messages 18
11 Basic information on the appliance 19
11.1 General description of the washing machine 19
11.2 Noise level 20
11.3 Data reg. the electrical and hydraulic equipment 20
11.4 Dimensions, technical data, installation instructions 20
12 Tips for self-help in the case of faults 21
13 Staff training 22
14 Authorized user of this documentation 22
15 Settings / modifications / on-site adaptation 23
15.1 Using the keyboard for programming 23
15.2 Code entry 23
15.3 Service level 24
15.4 Parameter list 29
15.5 Assignment list View inputs / control outputs 33
15.6 Rinse program parameter update: 01.05.2008 34
16 Operating errors 34
16.1 Information reporting and troubleshooting 35
16.2 Error messages and troubleshooting 36
17 Maintenance 38
17.1 Basic safety measures during normal operation 38
17.2 Dosing units 39
17.3 Maintenance plan 39
18 Environmentally acceptable measures, Disposal of the installation 40
19 Documentation 40
To Next Page
Loading...
