Use the qr-code on the side or connect to the www.cme.it page and follow the instructions.
Once you have found the specific code for your device, set it in the remote control as described in the
ENTERING THE CODE DIRECTLY chapter.
ATTENTION: searching for the suitable code could last up to 5 minutes.
• Stand in front of the device to be controlled and make sure it is ON (not in stand-by). If necessary, switch
it on using the original remote control (if this is still working) or the buttons present on the device itself. (on
TVs they can be on the side or the top)
• On the MELICONI remote control select the operating mode and then press and hold the button
until the LED of the remote control lights up; release.
• Pointing the remote control towards the device, PRESS AND HOLD the ON/OFF button and wait
(even up to 5 minutes) for the device to switch off or that a shutdown menu appears.
• PAY ATTENTION, when the device turn off, IMMEDIATELY RELEASE the button.
• Three final flashes indicate that the operation has been completed successfully.
(only to be performed if you know the specific code to be set)
• On the MELICONI remote control select the operating mode and then press and hold the button
until the LED lights up; release.
• Immediately enter the previously identified specific code.
• Three final flashes indicate that the operation has been completed successfully.
If the remote control does NOT carry out the three final flashes, the setting is NOT successful; repeat the procedure.
If still unsuccessful, it means that the code is not included in the remote control, contact the ASSISTANCE.
VERIFY
Check that the MELICONI remote control operates your device in the main functions; if it does not, REPEAT the
procedure.
NOTE: When the list of codes to be searched is over, the remote control exits the search and the LED remains off.
If no results are obtained, try using the procedure described in the SMARTPHONE - TABLET - WEB chapter or contact
the ASSISTANCE.
To Next Page
Loading...
