Using the MELICONI remote control to command 2 devices (TV and DECODER) it is often necessary to select the operating
mode before to operate on the corresponding device.
To avoid this uncomfortable and frequent operation, it is possible to combine in a single keyboard two different modes of use.
Automatically the V+ V- keys will control the TV, while the remaining keys will be the DECODER.
Operate as follows:
• On the MELICONI remote control press and hold the button until the LED lights up; release.
• Enter the code 0069.
• Three final flashes indicate that the operation has been completed successfully.
To obtain a function related to the other mode of use, for example the ON/OFF function of the DECODER, press and
hold the button and press the desired key ( + ).
To return to operate in the two distinct mode of use, carry out the procedure using the code 0096.
By activating the CHILD MODE, the remote control only enables the main functions:
NUMBERS V+ V- P+ P- EXIT
All other functions are blocked.
• On the MELICONI remote control press and hold the button until the LED lights up; release.
• Enter the code 0123.
• Three final flashes indicate that the operation has been completed successfully.
To restore all the original functions, insert code 0123 on the Meliconi remote control..
If necessary it is possible to completely reset the remote control and bring it back to the initial conditions.
WARNING : All user settings will be lost. Operate as follows:
• On the MELICONI remote control press and hold the button until the LED lights up; release.
• Enter the code 0279.
• Three final flashes indicate that the operation has been completed successfully.
To Next Page
Loading...
