The functions of the buttons on the MELICONI remote control are only available if the original device is equipped with it.
Sometimes some functions of the original remote control are not directly present on the MELICONI remote control keypad.
To enable them, connect to the www.cme.it page, use the on-line tool ACTIVATION OF REMOTE CONTROL and continue
until you see the list matching buttons between the original remote control and the MELICONI remote control.
If the function you want to play is matched with an number in orange color, operate as follows:
• On the MELICONI remote control select the operating mode and then press and hold the button.
• When the LED turn on, without releasing the button, point the remote control towards the device
and enter the previously identified number corresponding to the function you want to get. (at the last digit
pressure, the remote control already transmits this function)
• Release the buttons; to match the function obtained to a MELICONI remote control button, within 30
seconds, press and hold the desired button.
• Wait three flashes indicate that storage; release the button. (the used button loses the original function
that will be called by setting again the activation code)
The MEMO function allows you to record a sequence of functions (button) and combine it with a single call button.
Sometimes it is necessary to perform different operations in succession in order to obtain a certain result.
With MEMO function will be possible to automate a number of functions (also on different devices) without having to
remember and repeat every time you need.
The MEMO function records the pressure of a maximum of 31 buttons, (including possibile changes of operating mode) also
memorizing the pressure time and issue of the buttons.
Any button, except the button and the device selection buttons, can be used to record a MEMO function; obviously the
preset function on the button will be lost, but it can be restored by setting again the activation code.
To recall a MEMO function, press the button to which was matched, the remote control will play the entire sequence
memorized ignoring any other command until its end.
You can not create recursive or nested MEMO (MEMO functions that call other MEMO)
More MEMO functions can be recorded in the various remote control operation modes, up to maximum total of 8.
The recording of MEMO function can be repeated many times until the desired result is obtained, moreover the sequences
captured are kept in memory even with dead batteries or removed.
● MEMO RECORDING
• On the MELICONI remote control select the operating mode and then press and hold the button until the LED lights
up; release.
• Press the button again briefly and immediately press for a moment the button to which to combine the MEMO function.
• At this point the remote control is ready to record the desired button sequence; press in order the buttons to memorize with
the normal rhythm used to command the relative devices.
• To terminate the record procedure, press and hold button, wait three flashes indicate that storage; release.
From now when the designated button is pressed, the MELICONI remote control will automatically reproduce the sequence
of buttons memorised.
Reached the number of records available, the dedicated memory becomes full, preventing further use.
To free memory use one of the following procedures in relation to the data that you want to delete:
• DELETE FUNCTION BY SINGLE BUTTON
• ENTERING THE CODE DIRECTLY
• RESET THE REMOTE CONTROL
To Next Page
Loading...
Need help?
General
