6.8 Dispensing multiplicator products
Under product settings (see chapter 7.6 on page 23),
you can set up products as multiplicator products. With
this you can issue multiple portions of a product in suc-
cession if required, for example, to fill a larger cup.
Note
In order to dispense a multiplicator product,
there must be enough product material and
capacity in the coffee grounds drawer.
1. Position a cup underneath the beverage outlet.
2. Press the corresponding product button on the
display.
While the product is being dispensed, the display
shows how many single products are included in
the multiplicator product and which single prod-
uct is currently being dispensed (e.g., "1 / 4", the
first product of four single products).
The products are prepared and dispensed in suc-
cession.
9 The dispensing of the multiplicator product is
complete.
6.9 Multiple dispensing of a single product
Multiple portions of a product can be requested as
necessary and dispensed directly in sequence. The
advantage of multiple dispensing is that you do not need
to select the product again for every subsequent portion.
1. Position a cup underneath the beverage outlet.
2. Press the corresponding product button on the
display.
3. While the product is being dispensed, press the
"Repeat" button several times in succession
depending on the number of additional portions that
you would like to dispense.
The products are prepared and dispensed in suc-
cession.
4. Once a portion has been dispensed, put the cup aside
and place another cup underneath the beverage
outlet.
9 The multiple dispensing operation is complete.
6.10 Batch mode
Batch mode can be used to preselect multiple products
and dispense them in sequence.
SELECTION
PRODUCT
FILTER UNIT
Espresso
***
Café Crème
Steam
Hot water
Latte Macchiato
Ristretto
***
Cappuccino
Milk foam
cold
Café Crème
Cappuccino
**
Espresso
***
2
1
3
Fig. 23: Batch mode
Depending on the preset in the manager menu (see
chapter 7.1 on page 20), the batch mode (1) can be
switched on and off by default.
To switch the batch mode itself on or off, press the bar for
the batch mode (1) on the right of the display.
Product dispensing in batch mode
1. With batch mode switched on, press the products to
be dispensed in sequence.
2. Press the "" button (3) in the display to start dis-
pensing the first product.
3. Once a product has been dispensed from the batch,
remove it and position a suitable container for
the next product underneath the corresponding
beverage outlet.
Cappuccino
**
SELECTION
PRODUCT
FILTER UNIT
Pre-set batch input
Cappuccino
**
Espresso
***
1
2
Fig. 24: Product dispensing
Dispensing products
18
26288 • 20160202
6
To Next Page
Loading...
