Melitta Cafina XT6 - Dispensing a Double Product; Dispensing Multiplicator Products

6�6 Dispensing a double product
If this function is enabled by customer service, you can
request two portions of a coffee/milk product and fill two
cups simultaneously.
000144
1
2
1
2
Fig. 20: Dispensing a double product
1. Position a cup (2) in the center underneath each of
the dispensing nozzles (1).
2. Press the corresponding product button on the
display.
000156
Cappuccino
**
Double product
SELECTION
PRODUCT
FILTER UNIT
Pre-set batch input Repeat
Single product
1
2
Fig. 21: Dispensing a double product
3. Select one of the following options:
• Press the "Double product" button (2) to dispense
two portions of the requested product.
• Press the "Single product" button (1) to dispense
a single portion of the requested product.
Note
If neither the "Double product" button nor the
"Single product" button is pressed, a single
poron of the requested product is dispensed
aer a short me.
9 The product is dispensed.
6�7 Dispensing multiplicator products
Under product settings (see chapter 7.6 on page 23),
you can set up products as multiplicator products. With
this you can issue multiple portions of a product in suc-
cession if required, for example, to fill a larger cup.
Note
In order to dispense a multiplicator product,
there must be enough product material and
capacity in the coffee grounds drawer.
1. Position a cup underneath the beverage outlet.
2. Press the corresponding product button on the
display.
͵ While the product is being dispensed, the display
shows how many single products are included in
the multiplicator product and which single prod-
uct is currently being dispensed (e.g., "1 / 4", the
first product of four single products).
͵ The products are prepared and dispensed in suc-
cession.
9 The dispensing of the multiplicator product is
complete.
Dispensing products
17
26646 • 20160202
6