Melitta Cafina XT6 - Opening the Manager Menu

6�11 Preparing coffee from coffee powder
The manual coffee chute can be used to prepare coffee
from coffee powder without removing beans from the
bean container. This is normally used to prepare decaf-
feinated coffee. However, another type of coffee powder
can normally also be added via the chute.
000145
1
Fig. 25: Filling coffee powder
1. On the display, press the corresponding product
button for the product with manual coffee addition.
͵ The prompt for the manual coffee addition is
shown on the display.
2. Open the flap (1).
3. Add a loosely filled dosage spoon (approx. 8-9 g) of
coffee powder via the chute.
͵ Do not fill too much coffee powder into the chute.
Otherwise the machine cancels the operation
with an error message. The coffee powder will be
dispensed in the coffee grounds drawer.
4. Close the flap (1).
5. Confirm the filling process on the display.
9 The coffee addition is confirmed and the product is
dispensed.
7 Settings
The machine is preset to ensure that it is ready for
immediate use for normal operation.
The functions described here are only accessible if
enabled by customer service.
7�1 Opening the manager menu
The manager menu gives you access to advanced settings.
Button Function
Selection Activate products for dispensing,
create/manage product groups (see
chapter 7.4 on page 21)
Product filter Edit selection criteria for the product
filter in the waiter menu (see
chapter 7.5 on page 23)
Product Edit dispensing products (see
chapter 7.6 on page 23)
Unit Clean/switch off the machine
and change the filling levels (see
chapter 7.7 on page 24)
Operation Set up the machine, show
dispensing statistics, and display
important events (see chapter 7.8
on page 25)
000160
SELECTION
PRODUCT
FILTER UNIT
1 Espresso
***
2 Café Crème
9 Steam
4 Hot water
7 Latte Macchiato
5 Ristretto
***
Cappuccino
8 Milk foam
cold
...
PRODUCT OPERATION
Waiter operation Self-service operation Quick start
...
Release
Display
receptacle
Create new
group
Create new
product
Logout
Fig. 26: Manager menu
1. Hold the manager chip key on the contact area on
the front of the machine.
9 The display shows the manager menu.
Settings
20
26646 • 20160202
6
7