Adding products in batch mode
While products are being dispensed, you can add
products to the batch.
1. Press the "Pre-set batch input" button (2).
2. Press the products to be dispensed in succession.
9 The products are added to the batch.
6�10 Product dispensing via product filter
When dispensing products via the product filter, use
various selection criteria to select the required product
to be dispensed.
Depending on the preset in the manager menu (see
chapter 7.1 on page 20), the following criteria are
available:
Criteria Dispense setting
Size Portion size
Coffee Products with/without coffee, with
decaffeinated coffee, or with manual
coffee addition
Milk type Milk type or products without milk
Instant With/without instant powder or
corresponding instant powder
Syrup With/without syrup (manual addition
required)
Foam
consistency
Mousse, normal, or firm milk foam
Foam tem-
perature
Warm, normal, or hot milk foam
Heat milk Products with heated or cold milk
Milk
temperature
levels
Warm or hot milk
Preparation With milk or milk foam
1
SELECTION
PRODUCT
FILTER UNIT
Latte Macchiato
Cappuccino
**
SIZE
COFFEE
MILK TYPE
SYRUP
MILK TEMPERATURE LEVELS
FOAM TEMPERATURE
2
Fig. 24: Product dispensing via product filter
1. Select the required product to be dispensed using
these criteria in the product filter (1).
͵ Only products that match your criteria will be dis-
played. If multiple products meet your preselec-
tion options, these are displayed across multiple
pages.
2. Press the required product on the display (2) to
dispense the product.
9 The product is dispensed.
Dispensing products
19
26646 • 20160202
6
To Next Page
Loading...
