Why does no coffee flow from my Melitta SOLO?
If coffee isn't flowing from your Melitta Coffee Maker, the water tank may not be filled or properly inserted. Ensure the water tank is filled and correctly placed. Alternatively, the brewing unit could be clogged, requiring cleaning.
How to fix a Melitta SOLO that only dispenses coffee drop by drop?
If your Melitta Coffee Maker only dispenses coffee drop by drop, the grinding fineness may be too fine. Adjust the grinding fineness to be more coarse. Also, clean the brewing unit. If necessary, perform a descaling or cleaning program.
What to do if my Melitta SOLO says 'no water' when the tank is full?
If your Melitta Coffee Maker indicates "no water" even though the tank is full, it could be due to a blocked float or air in the lines. Check the condition of the float in the water tank, remove the water, and carefully shake the tank. If that doesn't work, fill the water tank and press the button for coffee strength to vent the appliance.
Why is the grinder not working on my Melitta SOLO?
If the grinder is not grinding on your Melitta Coffee Maker, it may be because the beans are not falling into the grinder. Try tapping lightly on the bean container. If this doesn't help, there might be foreign objects in the grinder.
What happens if the cleaning or descaling process is interrupted on my Melitta SOLO Coffee Maker?
If the cleaning or descaling process on your Melitta Coffee Maker was interrupted (e.g., due to a power outage), the appliance performs a rinsing program autonomously. Follow the instructions on the appliance to complete this process.
What does it mean when the cleaning and stand-by symbols flash on my Melitta SOLO?
When the cleaning and stand-by symbols flash alternately on your Melitta Coffee Maker, it indicates that the brewing unit is either missing or not properly inserted. Ensure the brewing unit is correctly inserted and locked. It could also mean that the brewing chamber is overfilled. In this case, switch off the appliance and switch it on again using the ON/OFF button (repeat if necessary) until standby mode is displayed.
What to do if the brewing unit of my Melitta Coffee Maker can't be reinserted?
If the brewing unit of your Melitta Coffee Maker cannot be reinserted after removal, ensure that the handle for locking the brewing unit is correctly engaged. Also, the actuator may not be in the proper position. To resolve this, switch the appliance off and then on again. Then press the button for single- and two-cup dispensing simultaneously for longer than 2 seconds to put the actuator into position. Then reinsert the brewing unit and make sure it is correctly locked into place.
Why are the bean symbols flashing on my Melitta SOLO when the bean container is full?
If the bean symbols are flashing on your Melitta Coffee Maker even though the bean container is full, it indicates an insufficient quantity of ground beans in the brewing chamber. Press the buttons for single-cup dispensing or two-cup dispensing to resolve this.
What does it mean when all the buttons are flashing continuously on my Melitta SOLO Coffee Maker?
Continuous flashing of all buttons on your Melitta Coffee Maker indicates a system error. Switch off the appliance and switch it on again via the ON/OFF button.
Risk of injury from electrical shock due to damaged appliance or cable.
Warning about hot surfaces, fluids, and steam causing burns.
Steps for venting, filling, and powering on the appliance for the first time.
Instructions for placing the appliance and connecting it to a power source.
Guide for inserting the Melitta PRO AQUA filter cartridge.
Solutions for problems with coffee dispensing and grinding.
Interpreting error symbols and resolving brewing unit insertion issues.
General| Milk tank | No |
|---|---|
| Product type | Espresso machine |
| Built-in grinder | Yes |
| Capacity in cups | -2 cups |
| Number of spouts | 2 |
| Coffee input type | Coffee beans |
| Coffee maker type | Fully-auto |
| Country of origin | Portugal |
| Appliance placement | Countertop |
| Water tank capacity | 1.2 L |
| Coffee beans capacity | 120 g |
| Maximum operating pressure | 15 bar |
| Reservoir for brewed coffee | Cup |
| Number of temperature settings | 3 |
| Control type | Buttons, Rotary, Slider |
| Display type | LCD |
| Product color | Silver |
| Housing material | - |
| Package depth | 545 mm |
| Package width | 300 mm |
| Package height | 380 mm |
| Package weight | 10500 g |
| Quantity per pack | 1 pc(s) |
| Customs code | 85167100 |
| Number of cartons per pallet | 24 pc(s) |
Weight and Dimensions| Depth | 455 mm |
|---|---|
| Width | 200 mm |
| Height | 325 mm |
| Weight | 9000 g |
To Next Page